Lifetime warranty by Peak Design
Slim, Lightweight Design
Works with all Peak Design Straps
Use on 11mm Standard Camera/Wrist Straps
Screws into Standard 1/4-20 Socket
Machined/Anodized Aluminum Construction
1 ON THE SIDE, 1 ON THE BOTTOM
We often recommend attaching 1 end of your PD strap to your camera's side strap lug (opposite the grip) and the other end to the bottom. These 2 connection points let the camera hang with the lens facing down for greater comfort and stability, especially with longer primes and zooms. Anchor Mount is the most low-profile, unobtrusive connection point available for PD Anchors and standard camera straps.
WORKS WITH ALL PD STRAPS:
Attach PD Anchors to increase your carry options with any of our straps. Compatible with all versions of our Anchors and straps.
WORKS WITH OEM STRAPS:
Attach any standard camera neck strap or wrist strap. Works with strap ends up to 11mm wide.
Ultra-secure 4mm hex drive with anti-twist pad.
FITS ANY CAMERA:
Screws into any standard 1/4""-20 tripod socket.
Rugged, weatherproof machined/anodized aluminum construction.
Note: Anchor Mount is not compatible with tripods or Capture system. If you frequently use a tripod or Capture, check out our Standard Plate.
Wrist Loop Size:
Diameter when open: 9.7 cm (3.82 in), but easily fits hands 5+ inches wide diameter when cinched: 4.5 cm (1.75 in)
19 mm (0.75 in)
Anodized aluminum plate with hard rubber anti-twist pad, turned/machined stainless steel hex-drive screw
Unpackaged: 18 g (.71 oz)
Packaged: 36 g (1.3 oz)
Length: 30 mm (1.2 in)
Width: 20 mm (.79 in)
Height (protrusion from camera): 5 mm (.20 in)
STRAP LOOP SIZE:
Fits straps up to 13mm (.51 in) wide
Can withstand well over 200 lbs (90 kg), making Anchor Mount safe for use with the largest of professional cameras.
Guaranteed for life.
1 x Anchor Mount
1 x 4mm hex key